Advertisement
Quick Links
Wireless Field Level Network Transceiver (FLNX)
Channel
Network I.D.
Figure 1. Wireless Field Level Network Transceiver
(FLNX).
Product Description
The FLNX (Figure 1) is mounted at or near the FLN
device and is powered by 24 Vac. The antenna can
either be direct-mounted to the radio, or mounted
remotely for installations where the location of the
FLNX would cause the antenna to be shielded. For
example, when the FLNX is mounted inside a TEC
enclosure.
Product Numbers
563-004
Wireless Field Level Network
Transceiver (FLNX)
563-007
Direct Mount Antenna
563-008
Remote Mount Antenna
Transceivers do not come with an
antenna. Antenna(s) must be ordered
separately.
Accessories
563-027
Pre-terminated Cable Kit (2 cables)
(One 14" Power and one 14" Comm. -
recommended for Factory Mounting)
Item Number: 563-002, Rev. 010
24 Vac 1.2VA
E H N
F L N
Installation Instructions
Warning/Caution Notations
WARNING:
Personal injury/loss of life may occur if you
do not follow the procedures as specified.
CAUTION:
Equipment damage or loss of data may
occur if you do not follow the procedures
as specified.
Expected Installation Time
5 minutes.
Tools
•
Electro-Static Discharge wrist strap
•
Small flat-blade screwdriver
•
Cordless drill/driver set
Prerequisites
All wiring must conform to NEC and local
•
codes and regulations.
•
24 Vac Class II power source available.
•
Any application specific hardware or devices
installed.
Antenna Mounting
Direct Mount Antenna
The preferred mounting configuration is to mount
the FLNX outside the TEC enclosure in a location
where it will establish the maximum number of
communication links with other FLNXs and its
associated FPX. For example, in a VAV application
this will typically be on the bottom of the VAV box in
the ceiling plenum with the entire antenna extending
below the VAV box (Figure 2).
Document No. 563-002
October 1, 2005
Page 1 of 4
Advertisement
Related Manuals for Siemens FLNX
Summary of Contents for Siemens FLNX
- Page 1 Product Description Tools • Electro-Static Discharge wrist strap The FLNX (Figure 1) is mounted at or near the FLN device and is powered by 24 Vac. The antenna can • Small flat-blade screwdriver either be direct-mounted to the radio, or mounted •...
- Page 2 Document No. 563-002 Installation Instructions October 1, 2005 Remote Mount Antenna The FLNX is mounted inside the TEC (or any metal) enclosure and the antenna is brought through a 1/2” knockout (Figure 3). The antenna extension cable 12” long. VAV BOX VAV BOX Figure 3.
- Page 3 (Figure 5) Fitting Nut and not the antenna so that the antenna can be articulated. 7. Connect the antenna wire to the FLNX. 8. Position the antenna in a vertical orientation (up or down). Antenna...
- Page 4 The Wireless Field Level Network Transceiver To comply with FCC’s RF exposure limits for general (FLNX) is to be installed or replaced by professional population / uncontrolled exposure, the antenna(s) installation personnel only. used for this transmitter must be installed to provide...