Advertisement
STARTING MOTOR
Both of them consist of yoke assembly, armature assembly, over-running clutch assembly, magnetic switch assem-
bly, front housing, rear housing, brush holder and drive lever.
The magnetic switch assembly and parts in the starting motor are enclosed in the housings so that they will be
protected against possible dirt and water splash.
NOTE:
Make sure to apply grease before assembly where so indicated "A" in the figure below.
1. Drive housing assembly
2. Washer
3. Snap ring
4. Pinion stop ring
5. Over-running clutch assembly
6. Armature
7. Pinion drive lever
8. Seal
9. Boot
10. Magnetic switch
11. Hold-in coil
12. Pull-in coil
13. Rear housing
14. Brush spring
15. Brush holder
16. Insulator
17. Bush
18. Brush
19. Yoke assembly
20. Housing bolt
"A": Apply grease (99000-25010)
CRANKING SYSTEM 6G-3
- Quick Links:
- Air Conditioning
- Oil Change
Hide quick links:
Advertisement
Chapters
