GE Giraffe Service Manual page 112
Hide thumbs
Also See for Giraffe:
- Service manual (212 pages) ,
- Operation and maintenance manual (90 pages)
Table of Contents
Advertisement
Chapter 5: Repair Procedures
7. Attach the ramp block to the heater mount with the two screws placed in the counter bore holes above,
and with two additional M3 x 10 Phillips Teflon coated screws and split ring lock washers.
8. Place the protective insert inside the insulating cylinder. Slide the bottom gasket over the insulating cylinder
then over the ramp block.
9. Align and slide the posts of the bottom bracket through the bottom gasket, then through the ramp block.
10. Install an M3 x 10 socket head cap screw and star washer through the hole in the heater mount next to the
add water thermostat. This screw grounds the bottom bracket so do not use a Teflon coated screw.
11. Route the heater and thermostat wire harnesses through the top gasket.
12. Install the top gasket and place the 4 0.125ID x 0.107L spacers into the gasket holes.
13. Route the heater and thermostat wire harnesses through the holes in the top bracket.
14. Install the reservoir switch button up through the bottom bracket and slide the switch actuator lever
through the button slot.
NOTE: Old style button installs down through the bracket.
15. Attach the reservoir switch to the top bracket using the two M3 x 16 Phillips screws, flat washers, and split
ring lock washers.
16. Align the top bracket with the mounting holes and install the four M3 x 12 Phillips screws and star washers
through the 4 holes in the top bracket. Attach the ground wire to the screw closest to the switch, using two
star washers.
17. Dress the wire harnesses and install a cable tie.
18. Slide the reservoir seal into place.
19. When installing the humidifier, rotate the cylinder so the max line is visible.
84
6600-0356-000 103
© 2001 by Datex-Ohmeda, Inc.. All rights reserved.
- Quick Links:
- Service Maintenance Schedule
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
