Table of Contents
Advertisement
Available languages
Available languages
K7046 Combined Installation
G
There are two models available, the first is RBC-RD1-PE. The RD1 is designed to be
installed next to the indoor unit, with the remote sensor and audible alarm located at
a low level and preferably under the indoor unit.
G
The RD1 is designed for use with MMS indoor units and RAV '4' Series AI indoor
units only.
G
The second model is the RBC-RD2-PE. The (RD2) is designed for use in the modular
multi outdoor unit. The unit will be located within the compressor housing, and it has
an internal sensor.
G
The RD2 can only be fitted to the MMS outdoor unit.
G
The functionality of both systems will be covered in indoor & outdoor operation
section of this manual.
G
There are two control PCB's inside the leak detector, each with jumpers which enable
specific functions to be enabled/disabled. The diagrams below show the locations of
these jumpers.
6/3/01
8:37 am
GB
Model Differentiation
Unit Setup
+ sig – mute + buzzer
AI
ALARM
N
JP
6
Page 6
L
control board
A B C
Sub PCB
Advertisement
Table of Contents
