Table of Contents
Advertisement
Chapter 3
Device Management
1.
Make sure the CLI is in Configuration mode.
2.
Navigate to interface » wan » {interface}, where {interface} is the WAN interface.
3.
Configure the following parameter(s) as required:
Parameter
{ slot }
{ port }
enabled
link-alarms
alias { alias }
4.
Configure a T1 or E1 line. For more information, refer to
Section 3.23.7, "Configuring an E1
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 3.23.3
Viewing WAN Statistics
To view statistics for the WAN network, type:
show interfaces wan t1e1
A table or list similar to the following example appears:
ruggedcom# show interfaces wan t1e1
interfaces wan t1e1 te1-2-1
slot
lm2
port
1
channelno
2
state
up
reliability 255/255
receive-stats
frames
227
bytes
6306
linkinactive 0
load
1/255
transmit-stats
txframes
217
txbytes
5733
txrealigned 0
load
1/255
receive-error
overrun
0
crcerror
0
134
Description
Synopsis: { sm, lm1, lm2, lm3, lm4, lm5, lm6, swport, eth, serport, celport }
The name of the module location for the WAN card.
Synopsis: An integer between 1 and 16
The port number on the WAN card.
Synopsis: true or false
Default: false
Enables this WAN port.
Synopsis: true or false
Default: true
Disabling link-alarms will prevent alarms and LinkUp and LinkDown SNMP traps from
being sent for that interface. Link alarms may also be controlled for the whole system
under admin / alarm-cfg.
Synopsis: A string 1 to 64 characters long
The SNMP alias name of the interface
Section 3.23.6, "Configuring a T1 Line"
Line".
RUGGEDCOM ROX II
CLI User Guide
or
Viewing WAN Statistics
Advertisement
Table of Contents
Troubleshooting
