Table of Contents
Advertisement
Items
Setting whether to limit the stack ca-
pacity of the stapled or folded
sheets
Setting whether to limit the stack ca-
pacity of the stack tray
Switching the high-productivity
punch mode or high-accuracy
punch mode of the puncher unit
Setting whether to perform the hor-
izontal registration operation of the
puncher unit for matching with the
center of the paper
Setting the punch hole specification
of the puncher unit
Setting ON/OFF of the mode to im-
prove the precision of the punch
hole position
Basic Adjustment Items
No
1
Adjusting Stacker Alignment Position
Adjusting Center Alignment Standard
2
Position
Right Angle Adjustment of Alignment
3
Adjusting the Paper
Plate
Alignment
4
Adjusting Delivery of Staple Stack
Adjusting the Return Roller/Swing Unit
5
Height
6
Adjusting the Staple Position
Adjusting the Sta-
ple Position
Adjusting the Stapler Unit Installation
7
Position
Service Mode
(SORTER > OP-
TION)
TRY-STP
When stacking papers beyond the maxi-
mum number of stapled copies/folded
sheets.
TRY-LMT
When the stacking performance decreases
by the curled paper during stacking a large
amount of the small size paper except the
thin paper and coated paper.
PUCH-SW
When switching the high-productivity punch
mode or high-accuracy punch mode.
PUN-Y-SW
When the adjustable range of the punch
hole horizontal registration adjustment
(PNCH-Y) is enlarged.
PNCH-SW2
When replacing the puncher unit.
PNCH-SW3
When the position of the punch hole is mis-
aligned.
Items
Use case
Use case
When misalignment occurs in front/rear di-
rection.
• When the standard position for the
center alignment is misaligned.
• When misalignment occurs in front/
rear direction.
• When remove or replace the align-
ment plate.
• When the paper alignment position is
displaced.
When the paper displacement occurs on
the 1st to 2nd sheets of buffered paper.
• When misalignment occurs in feed di-
rection.
• When misalignment occurs by failure
of the paper feeding to processing
tray.
When the staple position in front/rear di-
rection is displaced in the front/rear 1-sta-
pling mode or 2-stapling mode.
• When the stapler unit is replaced.
• When the staple position in feed di-
rection is displaced in the front/rear 1-
stapling mode or 2-stapling mode.
146
5. Adjustment
Remarks
When the stacking limit is
cleared, stacking capacity in-
creases, but stacking perform-
ance decreases.
- The settings of this mode and
the "Settings/Registration"
change at the same time.
- This mode is available when
the puncher unit has been in-
stalled.
This mode is available when
the puncher unit has been in-
stalled.
This mode is available when
the puncher unit has been in-
stalled.
- When setting to ON, the pro-
ductivity is decreased.
- When setting the punch mode
to the precision priority, this
mode enables.
- This mode is available when
the puncher unit has been in-
stalled.
Refer to
"Adjusting Stacker Align-
ment Position" on page
149
"Adjusting Center Align-
ment Standard Position "
on page 150
"Right Angle Adjustment
of Alignment Plate " on
page 151
"Adjusting Delivery of
Staple Stack " on page
154
"Adjusting the Return
Roller/Swing Unit Height "
on page 155
"Adjusting the Staple Po-
sition " on page 158
"Adjusting the Stapler
Unit Installation Position "
on page 159
- Quick Links:
- Finisher
- Specifications
Hide quick links:
Advertisement
Table of Contents
