Operation
6.10 Operation with the IOP
Calling the IOP wizards
The wizards are called in the "Wizards" menu in the lower area of the "Status" screen.
Figure 6-29
Prerequisites
Note
Restoring the factory setting
Every wizard provides an option that allows you to restore the factory settings. It is
recommended to accept this option.
Before the IOP application wizards are used, the following must be ensured:
● All required units are available and have been installed correctly in accordance with the
circuit diagram of the associated application wizard.
● The inverter, motor and the other units of the application have been wired in accordance
with the circuit diagrams (refer to the appropriate section of this manual).
● All components of the system have been checked for their correctness and proper
installation.
Required information for the wizards
The IOP wizards require during the setting task detailed technical information that must
always be available. The following information is available:
● Motor data – this data is contained on the motor type plate (see figure below).
● Sensor data – details for the sensor types that can be used for the inverter, e.g.
temperature and pressure sensors. The required information can normally be find on the
sensor type plate.
298
Status screen – "Wizard" menu marked
Inverter cabinet units
Operating Instructions, 12/2014, A5E32923362A