6 F 8 A 0 5 2 1
Terminal block
+24V
Power supply
Figure3.5.3 Terminals arrangement inside the RF section
[NOTE]
For connection between the converter and the RF section, connect cables according to
the band marks attached to the power cable (1) and the communication cable (2).
Erroneous connection can cause a failure or an erroneous operation.
[NOTE]
For connection between the converter and the RF section, make sure to use the attached
power cable (1) and communication cable (2). Using other cables can cause an erroneous
operation.
0V
T x+
Rx+
T x−
Rx−
FG
Communication
24
FG
EC+
NC
EC−
SG
FG
Conductivity signal input
(4 ~ 20 mADC)