Table of Contents
Advertisement
System information provided is IP Address, Software Version, Serial Number,
and MAC Address.
Settings
Admin
On the admin settings page, under the Security Settings header, the system
password can be changed, web access can be toggled, and call history can be
toggled. Under Device Settings the base's LEDs idle setting can be set, Dialer
Brightness can be adjusted, and Dialer Backlight Timeout time can be set.
Deployment Server settings is where the deployment server can be enabled or
disabled and automatic server discovery can be toggled on or off.
The system password required format is numerical. It is the same password
entered with the keypad to access the Admin Settings on the Dialer.
Disabling web access and then saving the changes will make the Web UI
unusable. Web Access must be reactivated through the Admin Setting menu
on the Dialer.
Toggling call history off will bring up a popup asking if the existing call history
should be deleted when the submit button is clicked to save changes.
Idle LED settings change the color the lights on the base will hold while a call
is not active.
The Brightness slider goes from 1-15.
Backlight timeout sets the time the dialer will spend at full brightness before
dimming again. Setting "Never" keeps the dialer lit all the time.
Audio
Speaker Volume and Ringer Volume can both be adjusted on a slider that goes
from 0 – 17.
Ringtone selection can be set using a dropdown menu to choose from available
ringtones. The selected Ringtone will play after "Submit" has been clicked to
save changes.
Equalizer settings available are Voice Enhance, Bass Boost, and Treble Boost.
High Pass filter can be set to None, 110Hz, 140Hz, 175Hz, or 225Hz.
USB Audio can be set to Always Enabled, Always Disabled, or User
Determined.
21
Advertisement
Table of Contents
