Table of Contents
Advertisement
5
Creating Project Files—Modbus Master to Devices
5.4
Device Setup—Port 2
One or more Siemens devices may be connected to
port 2. You must have a Modbus Master to Devices
Device Protocol
The Device Protocol indicates which Siemens devices
can be connected to port 2. This protocol is based on
which version of the DTU3005 Editor software was
installed as described in Chapter 2.
•
The SEAbus protocol (as shown in the example
screen above) indicates connection to Siemens
ACCESS communicating trip units, relays, power
meters and other devices.
•
The VDEW protocol indicates connection to Sie-
mens protective relays using the VDEW protocol.
Note: Not all Siemens devices are supported. For
a list of supported devices, see Appendix B.
Other Configuration Information
The remaining configuration selections are the same
as those for port 1. Refer to Section 5.3 for instructions
on these fields.
32
project file open to configure port 2 using the instruc-
tions in this section.
Select Port 2 (Devices) from the Edit menu, and the
Port 2 configuration screen appears.
Saving Port 2 Configuration Information
Once you have entered all the configuration informa-
tion, select Save to save the configuration to the
project file. Then select Ok or press the Esc key to
close the configuration screen.
If you have changed the configuration and have not
saved it to the project file, you will be prompted to
either save or discard the changes.
Select Revert to return to the last previously saved
configuration without saving any changes.
Siemens Energy & Automation, Inc.
- Quick Links:
- Product Overview
Hide quick links:
Advertisement
Table of Contents
