Table of Contents
Advertisement
STEP 4 Connect Serial Cable
If you have a DHCP server, the server automatically assigns an IP address to the
Access Point when you connect it to your network. To use the Access Point's
management system, you need to find out the assigned IP address.
If you have access to the DHCP server, you can look on the server to find the IP address
assigned to the Access Point.
If you cannot access the DHCP server, use a 9-pin, straight-through, male -to-female
serial cable to connect the COM 1 or 2 port on your computer to the RS-232 on the back
of the access point. After you find the assigned IP address, you can remove this cable.
You might need the cable again if you need to update the Access Point's configuration in
the future.
STEP 5 Ope n Terminal Program
Page 18 of 50
Advertisement
Table of Contents
