Table of Contents
Advertisement
The major inputs and outputs of the instrument are available at the front
panel:
• The external input (EXT INPUT) can be used to connect an external
• The strobe output (STROBE OUT) provides a signal indicating the
• The trigger signal (TRIGGER OUT) marks the start of each pulse
• The OUTPUT provides the signal output, the indicator shows the
NOTE
An input connector for external frequency reference (CLOCK/REF INP.)
is available at the rear panel (see
the rear panel option UN2 is ordered, all input and output connectors are
available at the rear panel.
NOTE
For information on the use of the memory card slot, refer to
Memory Card Screen" on page
arming source (triggered or gated modes), or to perform pulse
recovery (external width mode). For details, please refer to
Mode/Trigger Screen" on page
duration of a burst.
In burst mode, the STROBE OUT signal marks the start and end of
each burst of pulses generated. The rising edge of the STROBE signal
is synchronized to the start of the first pulse period in a burst, the
falling edge is synchronized to the start of the last pulse period in the
burst. (see
"The Mode/Trigger Screen" on page
You can set the output levels to TTL or ECL (see
Screen" on page
65)
period (see
"The Mode/Trigger Screen" on page
output levels to TTL or ECL (see
page
65).
current state of the output (on or off).
Introducing the HP 81101A Pulse Generator
44.
"The Trigger-Level Screen" on
"The Rear Panel" on page
67.
The Front Panel
"The
44).
"The Trigger-Level
44). You can set the
28). When
"The
19
Advertisement
Table of Contents
