Table of Contents
Advertisement
Interrupt) for the proper system configuration set up and other parameters (network
mode, ESS ID, and Tx rate) for the proper LAN card configuration.
7. Click on Bindings.
8. Click on the Protocol to access the network and share the resources.
9. Select TCP/IP and you can select either DHCP or Static for the IP address. If you
select DHCP, you do not need to specify the IP address. If you select the Static
option, enter the IP value, Subnet masking, Gateway, and DNS values respectively.
Also add the Workgroup/ Domain name
10. You can add the optional protocols such as NetBEUI.
11. After you add the TCP/IP protocol, it will ask you whether you want to restart your
computer or not. Click on Yes to make the changes effective and insert the PCMCIA
card in the PCMCIA slot. Now your network is established successfully, if your
PCMCIA card is detected. If you encounter some problems during installation or your
card is not functioning properly, please refer to the Troubleshooting at the end of the
manual.
4.2 Installation procedure of SWL-2100P PCI Card
Important: Do not insert the PCI card until you are asked to do so, failure of which may
result in unsuccessful installation of your PCI card.
Please follow the following steps one by one to install the PCI card successfully. There are
two cases: when there is no Windows NT networking Installed and the other when the
Windows NT networking is installed.
When Windows NT networking is not installed:
1. Power on your PC on and allow the Windows NT to load fully.
2. Now insert the Installation CD. Select the software Installation and click on Install.
3. Shut down your computer and insert the PCI card in the PCI slot and restart your
computer.
4. Since there is no Windows NT networking installed yet. You should install your
driver manually. To do so, click on start in task bar, go to Settings and then to
Control Panel.
5. Under Control Panel, double click on Network icon.
6. Since there is no Windows NT networking installed yet (If you have already installed
Windows NT networking, jump to the step 13 directly), you maybe asked if you want
to install NT networking first. Click on Next and then you will be asked how will
you access the network: modem or LAN. Check the proper selection and click on next.
17
Advertisement
Table of Contents
