Page 1
Instruction Manual TG105 Model Name Thank you for your purchasing TG105 terminal. ■ Read this instruction manual and use your KOMTRAX terminal correctly ■ ・Operators and service personnel for machines using KOMTRAX should make sure that they read and fully understand this document.
Page 2
Features ● TG105 uses LTE, UMTS, GSM and GPRS, so it can communicate in a lot of countries that they are used. (A communication contract is required in each place where TG105 will communicate, however.)
If you do not obey these precautions, neither Komatsu nor your Komatsu distributor can take any responsibility for any problem that is caused or for any loss that results. ■Injuries and damage which can be caused by wrong use of TG105 are explained as shown below. WARNING In the column with this mark, an item which "can cause...
Page 4
Neglecting this may cause a For anyone wearing a pacemaker, trouble, a fire, or an accident. the radio waves may have an Your Komatsu distributor will adverse effect on the operation of carry out removal and the pacemaker. installation.
Page 5
Prohibit Take the action given in "LONG-TERM Contact your Komatsu distributor before STORAGE" Operation installing a top guard or other attachment Maintenance Manual for the machine, that covers the antenna.
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body. This transmitter must not be co‐located or operating in conjunction with any other antenna or transmitter. TG105...
Page 7
Request for correct use Storage Do not store TG105 in a place where it will be exposed to direct sunlight, a place where the temperature is extremely low or the humidity is high, a place where there is much corrosive gas.
Page 8
8/11 Size and Outline TG105 160mm 90mm 125mm 150mm ① 36mm ② ① Interface connector (AMP) Connects the power cable and signal lines on the vehicle side. For details, see the specifications of interface connector. ② SIM card outlet SIM card can insert when rubber cover removed.
Page 9
9/11 Specifications of interface connector Connector on TG105 side: 174684-2 (Manufactured by TE connectivity) Pin Number Name Remark PWR_IN_GW Power supply PWR_CTR_GW Start up signal from another controller GND_PWR_GW DOS_L_RING Start up signal for another controller COMM_ETHER_RX+ Ethernet 100BASE-TX RX+...
10/11 Specifications TG105 Power source DC12V or DC24V (Operating range:DC10V~30V) Current consumption Communication Enabled:400mA Communication Disabled:185mA Standby State (Waiting for LTE only):4mA Interface Ethernet 100BASE-TX Digital input start up signal from another controller Digital output start up signal for another controller...
TG105 has trouble. Replace TG105. When start up signal line is turned Power source is not Check service power source, GND, and ACC ON, TG105 does not operate. supplied. line. Interface connector pins Correct interface connector pins. are wrong.