Table of Contents
Advertisement
HBA BIOS parameters
The table below shows the default value and the specified range of each HBA BIOS setup
parameter.
Table Setup items and values
Setup items
HBA BIOS
bios
ENABLE/DISABLE
BOOT PRIORITY
boot_priority
boot_device
boot_device_clear
SPINUP DELAY
spinup_delay
CONNECTION TYPE
connection_type
DATA RATE (*2)
data_rate
PERSISTENT
persistent_bindings
BINDINGS
ENABLE/DISABLE
FORCE DEFAULT
force_default_parame
PARAMETER
ter
Parameter
Default
Disable
Disable
-
All 0
0
-
Disable
Auto
Auto
Enable
Disable
133
Specified range
Enable/Disable
Sets HBA BIOS valid or
invalid.
It sets it to "Enable"
when using it as the
boot path.
Enable/Disable
Makes the list of the
boot devices effective.
When the priority level
is specified for the boot
device,
it sets it to "Enable".
1-8
It registers the boot
(Priority Level)
device (WWPN and
LUN) in the specified
priority level on the list
of the boot device.
(WWPN)
0-FFFF (LUN)(*1)
1-8
It deletes the boot
(Priority Level)
device (WWPN and
LUN) registered in the
specified priority level
from the list of the boot
device.
Enable/Disable
When the spinup
waiting time of max. five
minutes is inserted until
the disk becomes
READY, it sets it to
"Enable".
Auto
The connection type in
(Auto Detection)
the FC interface is
PtoP
specified. It usually uses
(Point to Point Only)
it by "Auto Detection"
loop
setting.
(loop Only)
Auto
The data rate in the FC
(Auto Detection)
interface is specified. It
1/2/4
usually uses it by "Auto
(Gbps Only)
Detection" setting.
Enable/Disable
When it is necessary to
invalidate the Persistent
Binding function, this
setting must be
"Disable".
Enable/Disable
When the driver is
instructed to disregard
the value set with the
parameter setting tool
(*3), and to use the
default value, it sets it to
"Enable".
Description
Advertisement
Table of Contents
