Table of Contents
Advertisement
Single Mode Operation
6/6: Mode Select & 1/6: Single Mode Setup
When using a pair of transmitter and receiver for the first time
Select the installation mode according to the situation in which the projector is installed.
When using in the single mode, it is necessary to perform the mutual authentication be-
tween the transmitter and the receiver. Setup them side by side as described below.
Main Menu 6/6: Mode Select
1. Press the MENU button to show the Menu. Press the Point de buttons to select Main
Menu 6/6: Mode Select and then press the SELECT button.
2. Press the Point 7 8 buttons to select the Single Mode.
3. Input signal will be displayed [S] in the lower left-hand corner.
Mode
Select
Main Menu 1/6: Single Mode Setup
a Sub Menu 1/2: Authentication
1. Press the MENU button to show the Menu. Press the Point de button to select Main
Menu 1/6: Single Mode Setup and then press the SELECT button.
2. Press the Point de buttons to select Sub Menu 1/2: Authentication and then press the
SELECT button.
3. Press the Point 7 8 buttons to move the bracket to [YES] and then press the SELECT
button to perform the authentication.
4. The message "Please wait ..." will be displayed and the transmitter is waiting for the
response from the receiver.
5. Set up the authentication of the receiver.
6. If the authentication is completed, the message "Success" will be displayed for 5 seconds
and the LINK indicator lights orange.
If it is not completed within about 5 minutes, the message "Failure" will be displayed for
5 seconds.
SingleMode 1/6
Setup
✐ If you press Menu button during authentication, the authentication will be cancelled.
SingleMode 1/6
Setup
6/6
Single
Hello
HD Data Wireless
Broadcast
Video
1/5
Setup
Wireless 2/5
Setup
Wireless 3/5
Initial Setup
Authenti- 1/2
cation
Initialize 2/2
Information 4/5
Key Lock 5/5
Key Lock 5/5
Input Lock Key
##[#]#
OK
Authenti- 1/2
INPUT SIGNAL >>
cation
<none>
INPUT SIGNAL >>
<none>
INPUT SIGNAL >>
Please wait...
<none>
INPUT SIGNAL >>
<none>
INPUT SIGNAL >>
Initialize 2/2
<none>
INPUT SIGNAL >>
Mode
[S]
<none>
Phase
Mode
Transmission
[OK] NG
Authentication
[Yes] NO
Initialize
[YES] NO
Link On
RF Freq. **.*MHz
INPUT SIGNAL >>
<none>
Input Lock Key
[#]###
OK
Input Lock Key
###[#]
OK
INPUT SIGNAL >>
<none>
INPUT SIGNAL >>
<none>
INPUT SIGNAL >>
<none>
INPUT SIGNAL >>
<none>
INPUT SIGNAL >>
<none>
TRANSMITTER
INPUT SIGNAL >>
[S]
XGA 1
1/2
H Position 2/2
Transmission
OK [NG]
Authentication
Yes [NO]
Initialize
YES [NO]
H Rez. ****
V Rez. ****
H Freq.
V Freq.
Input Lock Key
#[#]##
Input Lock Key
Authentication
####
YES [NO]
INPUT SIGNAL >>
Authentication
[B]
XGA 1
[YES] NO
INPUT SIGNAL >>
<none>
Success
INPUT SIGNAL >>
<none>
Failure
INPUT SIGNAL >>
<none>
INPUT SIGNAL >>
Initialize
<none>
[YES] NO
OK
[OK]
Advertisement
Table of Contents
