Tab le of c ont e nts Notes on the instruction manual........................3 Safety ................................. 3 Intended use..............................3 Environment ..............................4 ABB devices ............................4 Product description ............................5 Control elements ........................... 5 Technical data ..............................6 Mounting/Installation ............................7 Requirement for the electrician ......................
Please keep this manual in a safe place. If you pass the device on, also pass on this manual along with it. ABB accepts no liability for any failure to observe the instructions in this manual. Safety Warning...
ABB devices All packaging materials and devices from ABB bear the markings and test seals for proper disposal. Always dispose of the packing materials and electric devices and their components via an authorized collection facility or disposal company.
Product description Product description Control elements 100~240V Functions Bus in/out Operating mode settings See chapter "Operating modes" for details. Operating status indicating LED Ready for operation Fault Power supply │5 Product manual 2TMD041600D0157...
Technical data Technical data Designation Value Bus voltage 20-30 VDC Operating temperature -25 °C…+55 °C Storage temperature -40 °C…+70 °C Single-wire clamps 2 x 0.28 mm² - 2 x 0.75 mm² Fine-wire clamps 2 x 0.28 mm² - 2 x 0.75 mm² Protection IP 20 Size...
Mounting/Installation Mounting/Installation Warning Electric voltage! Dangerous currents flow through the body when coming into direct or indirect contact with live components. This can result in electric shock, burns or even death. – Disconnect the mains power supply prior to installation and/or disassembly! –...
Mounting/Installation General installation instructions Terminate all branches of the wiring system via a connected bus device (e.g., indoor station, ■ outdoor station, system device). ■ Do not install the system controller directly next to the bell transformer and other power supplies (to avoid interference).
Operation Operation Operating modes “One on” mode If there is an incoming call, all indoor stations in the same apartment ring together, but only the master indoor station switches on the screen. “All on” mode If there is an incoming call, all indoor stations in the same apartment ring and switch on screen at the same time.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Only operate the device in accordance with the instructions supplied.
We reserve the right to at all times make technical changes as well as changes to the contents of this document without prior notice. The detailed specifications agreed to at the time of ordering apply to all orders. ABB accepts no responsibility for possible errors or incompleteness in this document.
Page 13
Km 9 National Highway 1A , The detailed specifications agreed P.O.Box 11070 Dubai-UAE Hoang Liet, Hoang Mai, Hanoi, upon apply for orders. ABB accepts T : +971 4 3147 586 Vietnam no responsibility for possible errors F : +971 4 3401 541 T : +84 4 3861 1010 or incompleteness in this document.