Table of Contents
Advertisement
Figure 5-8: AC I/O Plate
Power Cabinet Alarm Cable
Power Cabinet Punch
Block
Apr 2001
SC
TM
V05.03
The objective of this procedure is to install the Power Cabinet alarm
cabling. This cable runs from the Power Cabinet to the RF Cabinet. It
can be run in the 3" DC Conduit.
Figure 5-9 details the location of the punch block, the input and output
pin identification, wire pair identification, and how the wires are inserted
for termination.
To ensure protection from surges, ground connection is
required before connecting any incoming lines.
Use only 110 style punch block punch tool to terminate
wires at punch block (ref: P/N CGDS237744 or
equivalent).
4812ET RF and Power Cabinet Hardware Installation Manual
DRAFT
CAUTION
WARNING
Cabinet Cabling
– continued
Route Ground
Cable Through
This Slot
107
5
Advertisement
Chapters
Table of Contents
