Husqvarna 135 Mark II Operator's Manual page 20

Hide thumbs Also See for 135 Mark II:

Table of Contents

1. Loosen the guide bar nuts that hold the sprocket

cover. Use the combination wrench.

2. Tighten the guide bar nuts by hand as tight as you

can.

3. Lift the top of the guide bar and extend the saw

chain by tightening the chain tensioning screw. Use

the combination wrench. Tighten the saw chain until

it does not hang down from the bottom of the guide

bar.

4. Tighten the guide bar nuts using the combination

wrench and lift the tip of the guide bar at the same

time.

5. Make sure that you can pull the saw chain round

freely by hand and that it does not sag.

To lubricate the cutting equipment

To do a check of the saw chain lubrication

Do a check of the chain saw lubrication each time you

refuel.

1. Start the product and let it run at 3/4 speed. Point the

nose of the guide bar at a light color surface almost

20 cm (8 in) away.

2. After 1 minute of running, a line of oil shows on the

light surface.

3. If you cannot see the line of oil after 1 minute, clean

the oil channel in the guide bar. Clean the groove in

the edge of the guide bar. Make sure the guide bar

nose sprocket turns freely and that there are no

blockages in the lubrication hole. Clean and lubricate

the tip sprocket.

862 - 001 - 20.09.2018

Table of Contents

Show Quick Links

Table of Contents

130 mark ii