Assembling Other Guards And Cutting Equipment; Assembling And Dismantling The Two-Part Shaft (225Ld, 227Ld) - Husqvarna 225L, 225LD, 227L, 227LD, 232L, 240L Operator's Manual
Clearings saws
Hide thumbs
Also See for 225L, 225LD, 227L, 227LD, 232L, 240L:
- Operator's manual (32 pages) ,
- Operator's manual (24 pages)
Table of Contents
Advertisement
Assembling other guards and
cutting equipment
• Fit the guard (A)
intended for use with
the trimmer head.
Secure using four bolts
(L) and the support plate
(M) as shown in the
diagram.
• Fit the disc drive (B) on
the output axle.
• Turn the blade axle until
one of the disc drive's
holes aligns with the
corresponding hole in
the gear housing.
• Insert the locking pin
(C) into the hole to lock
the axle.
• Screw on the trimmer
head (H) in the
direction of rotation.
• Dismantling takes place
in the reverse order.
ASSEMBLY
Assembling and dismantling the
two-part shaft (225LD, 227LD)
Assembling:
• Make sure the handle is
loose.
A
L
B
• Guide the cut-out on the
lower section of the shaft
into the coupling's
locking plate on the
upper section of the
C
shaft. The sections are
M
then locked together.
• Tighten the handle.
H
Dismantling
• Undo the handle (at least
three turns).
• Press the handle towards
the coupling.
• Carefully twist the lower
section out of the lock.
• Hold both parts of the
shaft and pull out the
lower section from the
coupling.
13
English –
- Quick Links:
- Trimmer Head
- Fuel Mixture
- Carburettor
- Spark Plug
- Technical Data
- 225L/Ld
Hide quick links:
Advertisement
Chapters
Table of Contents
