Tab Overview - Siemens SIMATIC Ident Operating Manual
Hide thumbs
Also See for SIMATIC Ident:
- System manual (362 pages) ,
- Function manual (142 pages) ,
- Operating instructions manual (58 pages)
Table of Contents
Advertisement
5.2
Tab overview
After successful establishment of a connection to the reader, the following tabs are available
depending on the connected reader type and the firmware version:
Table 5- 1
The tabs of the Ethernet-based readers RF640R/RF670R
Tab
Functionality
Info
Connection establishment to reader
•
Display of reader-specific information
•
Change language
•
Tag Data
Read and write functions for the memory
areas of a transponder.
Tag Events
Visualization of the transponder events
sent by the reader.
IO
Setting outputs and visualization of the
current statuses of the inputs.
RSSI
Display of the RSSI values of the read
transponders
Table 5- 2
The tabs of the serial readers RF620R/RF630R
Tab
Functionality
Info
Connection establishment to reader
•
Display of reader-specific information
•
Change language
•
Tag Data
Read and write functions for the memory
areas of a transponder.
RSSI
Display of the RSSI values of the read
transponders
Power Ramp
Visualization of the power set by the
(as of V2.0*)
reader per read cycle
Tag List
Display of the RSSI values read over time
(as of V2.0*)
and the read power used for them by the
reader.
Parameter
Boxes for setting the selected features
(as of V2.0*)
VSWR
Display of the VSWR value (voltage
standing wave ratio) of the connected
antennas.
Firmware-Update
Updating the firmware
(as of V1.04*)
*
Firmware version of the reader
)
SIMATIC RF-DIAG
Operating Manual, 09/2012, C79000-G8976-C292-01
Note/uses
Always visible
Precise indication of which reader type is
connected.
Test of the functionality of the reader
Check of transponder data
Test of the functionality of the reader
Test of the functionality of the reader
Optimization of the antenna alignment
Note/uses
Always visible. Precise indication of which
reader type is connected.
Test of the functionality of the reader
Check of transponder data
Optimization of the antenna alignment
Setting the optimum power ramp values.
Check of the effectiveness of the set UHF
features.
Setting of all UHF features
Read out of the quality characteristics of
the air interface
-
Operating the software
5.2 Tab overview
Adv. View
⃞
☑
⃞
⃞
⃞
Adv. View
⃞
☑
⃞
☑
☑
☑
☑
⃞
31
Advertisement
Table of Contents
