Advertisement
OPERATING SuperDrive 75
5. Attach the SuperDrive indexing module
5. Slide the SuperDrive 75 indexing module
onto the coupler and tighten the locking
wing nut clockwise.
6. Insert a collated strip of screws into the
6. Insert collated strip into the indexing module
indexing module guiding the strip through
the feed track and into the indexing guide.
7. Position the first screw in the strip in the
7. Position the first screw
center of the bit tip guide.
OPERATING SuperDrive 75
1. Remove factory nose piece and install the SuperDrive coupler
Attaching the extension
1. Remove the factory nose piece and bit from
the driver and install the SuperDrive 75
coupler as described in the instructions 1-3
(Attaching the indexing module) above.
2. Slide the SuperDrive handle onto the
2. Install the handle
coupler. Rotate the handle to the desired
position. Then rotate the grip clockwise
securing it into position.
3. Fit the bit rod extension into the driver.
3. Install the bit rod extension
4. Attach the SuperDrive extension tube to the
4. Attach the extension tube to the coupler
coupler. Rotate the extension tube counter
clockwise screwing it onto the coupler.
5. Insert the SuperDrive bit tip into the bit
5. Install the SuperDrive bit tip
holder.
6. Attach the SuperDrive 75 indexing module
6. Attach the SuperDrive 75 indexing module
to the extension tube and tighten the wing-
nut securing it to the extension tube.
ADJUSTING FOR FASTENER LENGTH(Coarse adjustment)
1. Loosen the Phillips set screw on the nose piece by rotating it
counter clockwise.
2. Move the nose piece in or out as needed to match
fastener length.
3. Tighten the set screw back down turning it clockwise to secure
the nose piece in place for operation.
FINE DEPTH ADJUSTMENT
Twist the knurled wheel at the top of the SuperDrive 75 indexing
module to make fine depth adjustment. An adjustment scale and
guide are located on the top of the tool.
SUGGESTIONS FOR OPERATION:
For best results position SuperDrive 75 at a right angle to the work
surface as much as is possible. Allow the driver to fully spin up
before pressing SuperDrive 75 to the sub-strait surface. Press
SuperDrive 75 to the sub-strait maintaining even and consistent
pressure until the fastener is fully driven in. Check fastener depth
and make any necessary fine adjustment. Keep the driver fully spun
up as subsequent screws are driven.
Check to see that the Hitachi driver is in the right (R) or forward
position before operating the tool.
R
Advertisement
