Configuring Wireless Adapter Settings
Touch
5
The
connected to the selected network and give an indication of signal strength.
To specify multiple networks to which the cardiograph can connect, repeat step 5 on
6
page 11 and the steps in this procedure as often as needed to configure the necessary set of
networks.
Configuration is complete. Proceed to "Step 4. Restarting the Cardiograph" on page 18.
Step 4. Restarting the Cardiograph
You must restart the cardiograph for the new wireless settings to be applied.
To restart the cardiograph
Press and hold down the On/Standby button (
1
cardiograph.
Press the power button again to restart the cardiograph.
2
The new wireless settings are applied and configuration is complete.
18
PageWriter TC20 Wireless LAN Installation Instructions
.
OK
tab
Wireless Information
field refreshes and should show that the cardiograph is
Status
) for five seconds to shut down the