Advertisement
Quick Links
Download this manual
See also:
Quick Reference Manual
Start Here
EPSON Stylus
CX6300
®
Please read these instructions before using the printer.
1
Unpack
1
Make sure you have all the parts shown here. If any parts are missing,
contact EPSON
®
as described on the back of this sheet.
EPSON Stylus CX6300
Software
Quick Reference
CD-ROM (3)
Guide
Paper support
Ink cartridges
Feeder guard
2
Remove all blue packing tape from the Stylus CX.
3
Lift up the scanner unit. If it doesn't open, make sure you have
removed all the tape.
4
Peel off the tape from the ink cartridge holder.
5
Lower the scanner unit.
2
Attach the Parts
1
Insert the paper support into the slots behind the Stylus CX, as shown.
2
Lower the feeder guard into the slots behind the scanner lid.
(Insert the hinges on the feeder guard into the corresponding
slots on the Stylus CX.)
3
Plug In and Turn On
1
Plug the Stylus CX into a grounded electrical outlet.
Do not connect the USB cable yet.
2
Press and hold the On button until the green lights come on.
On button
4
Select the Language
2
1
5
4
You can change the control panel interface language from English to French,
Spanish or Portuguese. Press the Setup button, then press the top button
on the left side of the LCD screen until Language appears. Press the Color
button, then press the bottom button on the right side of the LCD screen until
the language you want appears. Press the OK button to save the setting.
5
Install Ink Cartridges
Note: The ink cartridges included with the CX6300 have a lower yield due
to the ink loading process. This process is only performed the first time
you turn on the device and guarantees a better performance.
Caution: Keep ink cartridges out of the reach of children and don't drink
the ink.
1
Wait until you see "Initial Charge" displayed on the control panel.
2
Lift up the scanner section.
3
Shake the package of ink cartridges four or five times.
Then remove the cartridges from the package.
Caution: You must install all cartridges and leave them installed
for all types of printing. To avoid damaging the Stylus CX, never
move the print head by hand.
4
Open the cartridge cover.
5
Place each cartridge in its holder.
6
Press down on each cartridge until it clicks into place.
3
7
Close the ink cartridge cover, then close the scanner section.
The Stylus CX begins charging the ink delivery system.
Charging takes about 2 minutes. The green light flashes and the Stylus CX
makes various sounds. Don't turn it off while the green light is flashing or
you'll waste ink.
6
Load Paper
1
Extend the output tray.
Don't touch the green part
2
Slide the edge guide to the left.
3
Place a stack of paper against the right side of the feeder,
but don't push it in. Slide the edge guide against the paper.
continue
Turn over
Advertisement
Related Manuals for Epson Stylus CX6300
Summary of Contents for Epson Stylus CX6300
- Page 1 Charging takes about 2 minutes. The green light flashes and the Stylus CX makes various sounds. Don’t turn it off while the green light is flashing or you’ll waste ink. EPSON Stylus CX6300 Software Quick Reference Lower the feeder guard into the slots behind the scanner lid.
-
Page 2: Connect To Your Computer
Adding the Stylus CX to Print Center for Mac OS X Any Questions? Connect to Your Computer Make sure your Stylus CX6300 is turned on, then plug the USB cable Open the OS X Applications folder, Here’s where to look for answers: into any available USB port on your Macintosh.