Module mounting
The following shows the procedure to mount the module. In this procedure, mount the target module on the base unit.
Module mounting
Mount a new module on the same slot.
Connect the terminal block and connecters
*1
to the new module.
power supply to the module here.
Module mounting
completion (6) is stored in
'Online module change progress
status' (SD1617).
To "Module recognition"
*1 Insert the SD memory card (which was removed when the module was removed) to a new module, if MES interface module, high speed
data logger module, C intelligent function module, and OPC UA server module are used.
3 REPLACEMENT PROCEDURE
36
3.4 Changing a Module by Controlling Special Relays and Special Registers
Do not supply external
No
Yes
Check the items of troubleshooting No. 5,
and take the action.