Table of Contents
Advertisement
●In apartment buildings installed with systems that do not support the Earthquake Alarm（Warning),
Note
"Earthquake Setting" is not displayed on the setting screen. If you do not know which system is installed,
please contact store responsible for installation or the service and maintenance company.
●In the case of the Full Intensity Display, Intensity 3 and Intensity 4 can be set as separate settings once
the system has started receiving earthquake information.
●The volume increases to "High" at earthquake intensities of 5 or higher.
1
Touch
The Earthquake Setting Screen is displayed.
For how to start the settings, please see
page 50.
2
On the Earthquake Setting
Screen, touch
for the content
you wish to set
Volume
3
Select one of "Off/Low/Medium/High"
and touch
High, Medium, Low
Factory default
setting: medium
4
Finish settings
Press
state (state in which nothing is displayed on
the screen).
54
Earthquake Setting
on the Setup Screen
*The screen below is for selecting Controller settings.
(Consult with the company that installed the system or the administrating company.)
■When the system is set to
Full Intensity Display
The set volume will be emitted.
Off
No call Earthquake Alarm will be emitted.
(OFF Button) to go to the standby
終了
Setup screen
Touch
Earthquake Setting Screen
■When the system is set to
Simplified Intensity Display
Touch
any one
●The figure shows the case of the Full
Intensity Display.
Touch
1
any one
終了
OFF
Touch
any one
2
Touch
Advertisement
Table of Contents
