POWER SUPPLY
10.5–16 VDC @ 2A
Negative Ground Only
Figure 3. Typical Remote Station Arrangement
Installation Steps
Below are the basic steps for installing the transceiver. In most cases,
these steps alone are sufficient to complete the installation. Refer to
the Reference Manual for additional information.
1. Mount the transceiver to a stable surface using the brackets
supplied with the radio. Begin by attaching the radio's mounting
brackets to the bottom of the transceiver case (if not already
attached) using the four 6-32 x 1/4 inch (6 mm) screws supplied.
Figure 4
shows the mounting bracket dimensions.
4
TRANSCEIVER
DATA TELEMETRY
DEVICE
MDS SD4 Startup Guide
ANTENNA
SYSTEM
05-4669A01, Rev. A