Bosch PTA 2400 Original Instructions Manual page 17
Hide thumbs
Also See for PTA 2400:
- Original instructions manual (93 pages) ,
- Original instructions manual (10 pages) ,
- Original instructions manual (91 pages)
Table of Contents
Advertisement
Available languages
Available languages
OBJ_BUCH-940-002.book Page 17 Tuesday, June 9, 2009 1:44 PM
Assembly
Delivery Scope
Please also observe the represen-
tation of the delivery scope at the
beginning of the operating instruc-
tions.
Before assembling the saw stand, check if all
parts listed below are provided:
No.
Designation
Saw stand PTA 2400
Attachment set
1
5
Locking knob of the attach-
ment set
2
Retaining adapter
Retaining adapter fastening kit
12
consisting of:
– Assembly-sliding plate
– Hexagon bolt (M8 x 15)
– Washer
Workpiece support
8
6
Length stop
Locking knob of the length
7
stop
Carriage bolt (M6 x 46)
13
Power tool fastening kit
consisting of:
– Hexagon bolt (M8 x 50)
– Washer
– Wing nut
Additionally required tools (not in delivery
scope):
– Phillips screwdriver
– Spanner
Bosch Power Tools
Assembling the Saw Stand
– Carefully remove all parts included in the de-
livery from their packaging.
– Remove all packaging material.
Setting Up the Saw Stand (see figures A1 – A2)
– Lay the saw stand upside down on the floor
(legs facing upward).
– Push the locking pin 3 in and tilt the leg out-
ward until the locking pin can be heard to en-
gage.
Quan-
– Repeat this workstep with the other three
tity
legs.
1
– Turn around the saw stand to the working
2
position.
2
The manufacturer logo must face toward the
front so that it can be read.
– Ensure that the saw stand is stable and that
2
all locking pins have engaged.
The saw stand is easily aligned with the height-
adjustable leg 4.
4
4
– Loosen lock nut 14 and screw the leg in or
4
out until the saw stand is aligned level and all
four legs face against the floor.
2
2
Mounting the Length Stop and Workpiece
Support (see figures B1–B2)
2
– Screw the length stop 6 to the workpiece
support 8 with carriage bolt M6 x 46 and
2
locking knob 7.
– Insert the workpiece support into the table
extension 10.
4
– Tighten the locking knob 9 to lock the work-
8
piece support.
4
– Repeat the worksteps with the second work-
piece support.
English | 17
1 609 929 T64 | (9.6.09)
- Quick Links:
- English | 15
- Svenska | 53
Hide quick links:
Advertisement
Table of Contents
