BL-PA100A/BL-PA100KTA
8.1.3.
Check the transmitting and receiving function
8.1.3.1.
Test equipment
1) Standard PLC
2) Power Strip with noise filter
3) Ethernet Cable
4) Power cord
8.1.3.2.
Connect Adaptors and Initializes
1) Set Standard PLC
Mode Selector Switch is set to MASTER.
2) Set Test PLC
Mode Selector Switch is set to TERMINAL.
3) LAN Jack
Connect both LAN Jack with an ethernet cable
4) Power ON
Plug the Power cord in the same side of the Power Strip.
5) Reset both PLC to factory default
Push each FACTRY DEFAULT RESET Button of Standard PLC and the Test PLC for about two seconds.
14