Husqvarna AUTOMOWER 440 Operator's Manual page 29
Hide thumbs
Also See for AUTOMOWER 440:
- Operator's manual (153 pages) ,
- Workshop manual (60 pages) ,
- Quick manual (8 pages)
Table of Contents
Advertisement
Use the right and left arrow keys to alternate between
the different options.
3.17.3.2 Area 1-5 > How far?
Enter the distance in metres along the current wire from
the charging station to the remote area where the
robotic lawnmower begins mowing.
Use the right and left arrow keys to alternate between
the different options.
Test function ( Area 1-5 > More > Test ) to
Tip! Use the
determine how far it is to the remote area. The distance,
stated in metres, will be shown in the lawnmower display
when STOP has been pressed. See
the distance to a remote area on page 29 . The
measured distance shown in the display can be saved
directly to the selected remote area. Any current value
will be overidden by the new measured distance.
3.17.3.3 Area 1-5 > How often?
How often the robotic lawnmower must be steered to the
remote area is selected as a proportion of the total
number of times it leaves the charging station. At all
other times, the robotic lawnmower starts to mow at the
charging station.
Select the percentage that corresponds to the size of the
remote area relative to the total working area. If the
remote area is for instance half of the total working area,
50% must be selected. A lower figure must be specified
if the remote area is smaller. If more areas are used,
take into account that the total figure cannot exceed
100%.
Compare with the examples in
page 40 .
Use the number keys to specify share as a percentage.
447 - 001 -
How to measure
? m / ft.
Yard layout examples on
20%
30%
3.17.3.4 Area 1-5 > Disable
Each area can be disabled and enabled without having
to reenter the settings. Select
3.17.3.5 Test: Area 1-5
To test the selected settings:
1. Place the robotic lawnmower in the charging station.
2. Use the down and the right/left arrow keys to select
the area to be tested from the
overview screen. Press OK.
More and press OK.
3. Select
Test and press OK.
4. Select
5. Press START and close the hatch.
6. The robotic lawnmower will now leave the charging
station and begin following the guide wire toward the
remote area. Check that the robotic lawnmower can
follow the guide wire all along the required distance.
7. The test is approved when the robotic lawnmower
can follow the guide wire to the required starting
point without any problem.
3.17.3.6 How to measure the distance to a remote area
1. Park the robotic lawnmower in the charging station.
Area 1-5 > How far? menu function, enter a
2. In the
distance which beyond any doubt exceeds the real
figure. The maximum distance that can be entered is
500 metres.
3. Select
Area 1-5 > More > Test and press OK.
4. Press START and close the hatch.
5. Press STOP at the required position. The distance is
now shown in the display. This figure can now be
Area 1-5 > How far? .
saved in
3.17.3.7 Area 1-5 > More > Reset
An individual area setting can be reset to the factory
setting using this function. To reset an area setting,
Area 1-5 > More > Reset using the left right arrow
select
keys followed by OK.
3.17.4 Find charging station
The robotic lawnmower can be set to search for the
charging station in one or more of the following three
ways: Guide, Boundary loop and Charging station. The
factory settings are set so that these 3 search options
Disable and press OK.
Lawn coverage
Installation - 29
Hide quick links:
Advertisement
Table of Contents
