HP 9000 Installation Manual page 7

D class and r class i/o card installation

Hide thumbs Also See for 9000:

I/O Card Installation Guide

Required Tools

I/O Card Installation Overview

To install I/O cards, you must turn off system power, and disassemble the system to

gain access to the cabinet interior. An overview of the procedure is given below:

A. Turn off power to the system.

B. Remove the front bezel.

C. Remove the side panel.

D. Remove the EMI cover.

E. Remove the I/O card retainer bracket.

F. Remove the I/O slot cover plate from bulkhead.

G. Set I/O card configuration.

H. Install HSC cards.

I. Install EISA cards.

J. Replace the I/O card retainer bracket.

K. Replace the EMI cover.

L. Replace the side panel.

M. Replace the front bezel.

N. Refer to I/O card-specific documents.

After completing all desired procedures, you should proceed to the I/O Card

Installation Verification section later in this chapter for procedures to verify that I/

O cards have been correctly installed.

•

Small flat-bladed screwdriver

•

Torx driver, #15

•

Torx driver, #10

•

Phillips screwdriver.