Samsung LTN133AT08-101 Service Manual page 27

Tft-lcd
Table of Contents

Advertisement

Global LCD Panel Exchange Center
2. STORAGE
(a) Do not leave the module in high temperature, and high humidity for a long time.
It is highly recommended to store the module with temperature from 0 to 35 °C and
relative humidity of less than 70%.
(b) Do not store the TFT-LCD module in direct sunlight.
(c) The module shall be stored in a dark place. It is prohibited to apply sunlight or fluorescent
light during the store.
3. OPERATION
(a) Do not connect,disconnect the module in the " Power On" condition.
(b) Power supply should always be turned on/off by following item 6.3
" Power on/off sequence ".
(c) Module has high frequency circuits. Sufficient suppression to the electromagnetic
interference shall be done by system manufacturers. Grounding and shielding methods
may be important to minimize the interference.
(d) The cable between the back-light connector and its inverter power supply shall be a
minimized length and be connected directly . The longer cable between the back-light
and the inverter may cause lower luminance of lamp(CCFT) and may require higher
startup voltage (Vs).
(e) The standard limited warranty is only applicable when the module is used for general
notebook applications. If used for purposes other than as specified, SEC is not to be
held reliable for the defective operations. It is strongly recommended to contact SEC
to find out fitness for a particular purpose.
4. OTHERS
(a) Ultra-violet ray filter is necessary for outdoor operation.
(b) Avoid condensation of water. It may result in improper operation or disconnection
of electrode.
(c) Do not exceed the absolute maximum rating value. ( the supply voltage variation, input
voltage variation, variation in part contents and environmental temperature, so on)
Otherwise the module may be damaged.
(d) If the module displays the same pattern continuously for a long period of time,it can be
the situation when the image "sticks" to the screen.
(e) This module has its circuitry PCB's on the rear side and should be handled carefully in
order not to be stressed.
6DPVXQJ 6HFUHW
Doc.No.
LTN133AT08-101
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
www.panelook.com
Rev.No
04-A00-G-080929
Approval
Page
27
/ 30
www.panelook.com

Advertisement

Table of Contents
loading

Table of Contents