Table of Contents
Advertisement
INSTALLING THE DEVICE ONTO YOUR VEHICLE
Before you start - Select a position to install the cradle that will not block driver's
field of vision and clean the place before installation.
1. Attach the suction cup to the place you selected
completely and push the locking tab in the
direction of the arrow shown by the fi gure.
The suction cup is secured.
2. Insert the catches of the stand to the Cradle
Fixing Grooves and slide the cradle so that
the catches are in the CLOSE position.
3. Insert the main unit into the cradle.
Put the main body into the cradle until it clicks
at the both side of the fi xing parts in order to
secure the installation.
4. Adjust the angle of the support to facilitate
your visibility.
Release the adjustment screw 1 counterclockwise
slightly and adjust the angle between the 180
degrees in vertical and 360 degrees in horizontal. If
you fi nd a comfortable angle, fasten the adjustment
screw 1 by turning it clockwise.
Release the adjustment screw 2
counterclockwise slightly and adjust the
angle between the 180 degrees in horizontal.
If you fi nd a comfortable angle, fasten the
adjustment screw 2 by turning it clockwise.
the basics _ 17
Advertisement
Table of Contents
