8. If the installed Wi-Fi card supports the Bluetooth function, connect a Bluetooth cable to the Wi-Fi
adapter.
Note: The Bluetooth cable connects the Bluetooth connector on the Wi-Fi adapter to the 15-in-1 card
reader connector on the system board. See "Parts on the system board" on page 38.
9. Attach the Wi-Fi antenna cable connectors
shown.
Figure 155. Installing the Wi-Fi antenna
10. Tighten the Wi-Fi antenna cable connectors to secure them to the rear of the computer.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 220.
Device in the 5.25-inch flex module
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
The following devices are supported in the 5.25-inch flex module.
• 15-in-1 card reader
• eSATA connector or IEEE 1394 connector
• Four-digit diagnostics display
• Front Thunderbolt adapter kit
• Slim optical drive
1
to the corresponding Wi-Fi antenna connectors
Chapter 9
.
Hardware removal and installation
2
as
185