Huawei SmartLogger1000 Quick Manual page 11

Hide thumbs Also See for SmartLogger1000:

Table of Contents

1. Remove an appropriate length of the steel armor and insulation layer from one end of the cable

using a wire stripper.

Unit: mm

2. Remove the terminal block from the SmartLogger COM port.

3. Connect the cable to the SmartLogger terminal block.

(1) Wiring terminal

NOTE

1. Press the white contact plate of the corresponding wiring terminal to flip the metal spring inside

the wiring terminal.

2. Insert the uninsulated part of the core wire into the wiring terminal.

3. Release the white contact plate to fasten the core wire.

4. Insert the terminal block into the SmartLogger COM port.

5. Remove an appropriate length of the steel armor and insulation layer from the other end of the

cable using a wire stripper.

Unit: mm

6. Connect the cable to the protection port on the RS485 signal SPD.

(2) White contact plate

NOTICE

Verify that the COM+ port on the

SmartLogger connects to protection port 2 or

8 on the RS485 signal SPD, and that the

COM– port on the SmartLogger connects to

protection port 6 or 12 on the RS485 signal

SPD.

Table of Contents

Show Quick Links

Table of Contents