SAMSUNG IPX-G5X0 Installation Manual v1.0
IPX-G500B Basic Configuration
Once connected via serial to the IPX-G500B, you can enter your network information into the gateway.
There are options to setup the gateway in a LAN or NAT configuration (see examples in the following
pages). Use the following steps to enter network information.
Select '1. Setup Basic Configuration'.
According to the prompt, select the network mode. LAN or NAT
If you select NAT:
Enter the WAN IP Address, Gateway and Subnet Mask of the IPX-G500B.
Enter the LAN IP Address, Gateway and Subnet Mask of the IPX-G500B.
If you select LAN:
Enter the LAN IP Address, Gateway and Subnet Mask of the IPX-G500B.
Enter the SCM Composite IP Address.
Enter the Gateway Name. This must match the Gateway Name in the SCM Configuration.
After all information is entered it will ask if you want to reset the system to apply the changes.
To reboot the system enter 'yes', otherwise enter 'no'
######
1. Enter Networkmode [0:LAN / 1:NAT]
######
1. Enter WAN IP Address
2. Enter Gateway Address
3. Enter WAN IP Subnet Mask (Enter Key : 255.255.255.0 ) :
######
1. Enter LAN IP Address
2. Enter LAN IP Subnet Mask (Enter Key : 255.255.255.0 ) :
######
1. Enter SCME IP Address (Enter Key : 10.251.0.100 ) :
######
1. Enter Name of this GW (Enter Key : G500_default
End of Configuration. To apply it, please restart the system.
Do you want to restart? (yes/no) :
Please enter network mode of this GW
Please enter [WAN IP/Gateway/Subnet Mask] of this GW
(Enter Key : 10.251.0.10 ) :
(Enter Key : 10.251.0.1
Please enter [LAN IP/Subnet Mask] of this GW
(Enter Key : 192.168.0.1
Please enter the IP Address of SCME
Please enter the name of this GW (Max 30char)
(Enter Key : NAT) :
) :
) :
) : G500Site1
Mar 2016
######
######
######
######
######
16