Complete The Parts Replacement - Lenovo ThinkSystem SR650 Maintenance Manual
2u rack server
Hide thumbs
Also See for ThinkSystem SR650:
- Setup manual (226 pages) ,
- Product manual (87 pages) ,
- Quick start manual (14 pages)
Table of Contents
Advertisement
http://sysmgt.lenovofiles.com/help/topic/toolsctr_cli_lenovo/onecli_r_set_command.html
3. Alternatively, you can use the following Advanced Settings Utility (ASU) commands:
To enable secure boot:
asu64.exe set SecureBootConfiguration.SecureBootis Enabled -v --override --host <ip_address>
--user <userid> --password <password>
To disable secure boot:
asu64.exe set SecureBootConfiguration.SecureBootis Disabled -v --override --host <ip_address>
--user <userid> --password <password>
To read the secure boot setting:
asu64.exe show SecureBootConfiguration.SecureBootis -v --override --host <ip_address>
--user <userid> --password <password>
where:
– <userid> and <password> are the credentials used to the BMC (Lenovo XClarity Controller
interface) of your server. The default user ID is USERID, and the default password is PASSW0RD
(zero, not an uppercase o).
– <ip_address> is the IP address of the BMC.
Complete the parts replacement
Use this information to complete the parts replacement.
To complete the parts replacement, do the following:
1. Ensure that all components have been reassembled correctly and that no tools or loose screws are left
inside your server.
2. Properly route and secure the cables in the server. Refer to the cable connecting and routing information
for each component.
3. If you have removed the top cover, reinstall it. See "Install the top cover" on page 104.
4. Reconnect external cables and power cords to the server.
Attention: To avoid component damage, connect the power cords last.
5. Update the server configuration if necessary.
• Download and install the latest device drivers:
• Update the system firmware. See "Firmware updates" on page 7.
• Use the Lenovo XClarity Provisioning Manager to update the UEFI configuration. For more
information, see:
http://sysmgt.lenovofiles.com/help/topic/LXPM/UEFI_setup.html
• Use the Lenovo XClarity Provisioning Manager to configure the RAID if you have installed or removed
a hot-swap drive, a RAID adapter, or the M.2 backplane and M.2 drive. For more information, see:
http://sysmgt.lenovofiles.com/help/topic/LXPM/RAID_setup.html
http://datacentersupport.lenovo.com
.
Chapter 3
Hardware replacement procedures
203
- Quick Links:
- DIMM Installation Rules
Hide quick links:
Advertisement
Table of Contents
