network as this speaker.
• Reconnect your mobile device to the network.
• Restart or reset your wireless router.
Audio is interrupted or playback does not start.
• When using the 2.4 GHz band on the wireless router,
simultaneous use of other 2.4 GHz devices (cordless
telephones, microwaves, etc.) may result in connection
interference. Increase the distance between the speaker
and these devices.
• Try using the 5GHz band, if supported by your router. Refer
to your router's Owner's Guide for more information.
• Do not place the speaker inside a cabinet made of metal.
Doing so may block the Wi‐Fi signal.
• Place the speaker closer to your wireless router.
• If several wireless devices are simultaneously using the
same network as the speaker, try turning off the other
devices or reducing their network usage.
Resetting the AllPlay Adaptor to factory
default
To return all settings to the factory defaults
1. Turn the Allplay Adaptor on.
If the Wi‐Fi LED is blinking WHITE and RED, proceed to the next
step after the LED turns solid WHITE (wait approximately 60
seconds).
2. Press the Reset key with the PIN through the RESET hole
(located at the back of the Adaptor).
3. The Bluetooth and Wi‐Fi LEDs will blink three times
simultaneously when the factory reset is complete.
4. After the factory reset is complete the Adaptor will take 60
seconds to reboot. The Adaptor will then be ready to set up again.
HITACHI Allplay Adaptor User`s Guide
19