Administration via Local Phone
|
--- Administration
|
--- Network
|
--- Update Service (DLS)
|--- DLS address
|--- DLS port
|--- Contact gap
|
--- Security status
3.3.8
SNMP
The Simple Network Management Protocol is used by network management systems for mon-
itoring network-attached devices for conditions that warrant administrative attention. An SNMP
manager surveys and, if needed, configures several SNMP elements, e.g. VoIP phones.
The OpenStage 60/80 supports SNMP version 1 and 2.
Data required
•
Trap sending enabled: Enables or disables the sending of a TRAP message to the SNMP
manager.
Value range: „Yes", „No".
•
Trap destination: IP address or hostname of the SNMP manager that receives traps.
•
Trap destination port: Port on which the SNMP manager is receiving TRAP messages.
•
Trap community: SNMP community string for the SNMP manager receiving TRAP mes-
sages.
•
Diagnostic sending enabled: Enables or disables the sending of diagnostic data to the
SNMP manager.
Value range: „Yes", „No".
•
Diagnostic destination: IP address or hostname of the SNMP manager receiving diag-
nostic data.
•
Diagnostic destination port: Port on which the SNMP manager is receiving diagnostic
data.
•
Diagnostic community: SNMP community string for the SNMP manager receiving diag-
nostic data.
•
QoS traps to QCU: Enables or disables the sending of TRAP messages to the QCU serv-
er.
•
QCU address: IP address of the QCU server.
•
QCU port: Port on which the QCU server is listening for messages.
•
QCU community: QCU community string.
•
QoS to generic destination / QoS to generic device: Enables or disables the sending of
QoS traps to a generic destination.
Value range: „Yes", „No".
A31003-01010-M11-1-7619, 29/01/2007
HiPath 8000 - OpenStage 60/80, Administrator Manual
administration.fm
Administration
IP Network Parameters
3-19