ABB REC670 Applications Manual page 157
Relion 670 series, bay control
Hide thumbs
Also See for REC670:
- Applications manual (658 pages) ,
- Commissioning manual (218 pages) ,
- Product manual (139 pages)
Table of Contents
Advertisement
1MRK 511 401-UEN A
Bay control REC670 2.2 IEC
Application manual
txMin: Minimum operate time for all inverse time characteristics. At high currents
the inverse time characteristic might give a very short operation time. By setting
this parameter the operation time of the step can never be shorter than the setting.
Setting range: 0.000 - 60.000s in steps of 0.001s.
IxMult: Multiplier for scaling of the current setting value. If a binary input signal
ENMULTx (enableMultiplier) is activated the current operation level is increased
by this setting constant. Setting range: 1.0-10.0
Operate time
tx
txMin
IMinx
IEC10000058 V2 EN-US
Figure 60:
Minimum operate current and operate time for inverse time
characteristics
In order to fully comply with the definition of the curve, the setting parameter
txMin shall be set to a value equal to the operating time of the selected inverse
curve for twenty times the set current pickup value. Note that the operate time is
dependent on the selected time multiplier setting kx.
ResetTypeCrvx: The reset of the delay timer can be made as shown in Table 20.
Table 20:
Reset possibilities
Curve name
Instantaneous
IEC Reset (constant time)
ANSI Reset (inverse time)
The delay characteristics are described in Technical manual. There are some
restrictions regarding the choice of the reset delay.
For the definite time delay characteristics, the possible delay time setting
instantaneous (1) and IEC (2 = set constant time reset).
Current
IEC10000058
Curve index no.
1
2
3
Section 8
Current protection
151
- Quick Links:
- This Manual
Hide quick links:
Advertisement
Table of Contents
