Nokia 7368 Product Manual page 58
Intelligent services access
manager cpe
Hide thumbs
Also See for 7368:
- Product manual (176 pages) ,
- Product manual (162 pages) ,
- Product manual (170 pages)
Table of Contents
Advertisement
Replace an A-240Z-A CPE
56
9
Connect the power cable to the power connector.
10
If applicable, install the power supply according to manufacturer specifications.
Note —
Observe the following:
•
Units must be powered by a Listed or CE approved and marked
limited power source power supply with a minimum output rate of
12 V dc, 1.25 A.
11
Power up the unit by using the power switch.
12
Verify the CPE LEDs and voltage status; see the 7368 Hardware and Cabling Installation
Guide.
13
Activate and test the services; see the 7368 Hardware and Cabling Installation Guide.
14
If necessary, reset the CPE.
i
Locate the Reset button on an A-240Z-A CPE as shown in Figure 14.
ii
Insert the end of a straightened paper clip or other narrow object into the hole in the
Reset button to reset the CPE.
15
STOP. This procedure is complete.
3FE-46615-AAAA-TCZZA
7368 ISAM CPE A-240Z-A Product Guide
Issue: 01
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
