Using The Sr+ Mode With A Pioneer; Plasma Display - Pioneer VSX-D814 Operating Instructions Manual
Audio/video multi-channel receiver
Hide thumbs
Also See for VSX-D814:
- Operating instructions manual (75 pages) ,
- Service manual (84 pages) ,
- Operating instructions manual (146 pages)
Table of Contents
Advertisement
Setting up the receiver
3
Press TEST TONE to output the test
tone.
The test tone is output in the following order
(depending on the speaker setting):
L
C
SW
LS
• If you don't hear a test tone from one of
your speakers, please refer to Speaker
setting on page 43 and Surround back
speaker setting on page 44 to make sure
you have correctly specified your speaker
setup.
4
Press MASTER VOLUME +/– to adjust
the volume to an appropriate level.
5
Use LEVEL +/– to adjust the speaker
levels in turn.
You should hear the test tone at the same
volume from each speaker when seated in the
main listening position. The channel level
range is ± 10 dB.
6
When you're done, press TEST TONE to
turn off the test tone.
The receiver returns to the Standard mode.
• The speaker volume can be adjusted
without outputting the test tone by
pressing CH SELECT and then using
LEVEL +/–. However, you can only adjust
the level of the speakers currently active
in the mode you're listening to. You can
set separate levels for the STANDARD,
STEREO and DVD 5.1 ch modes, as well
as for each ADVANCED SURROUND
mode.
• Since the subwoofer transmits an ultra-
R
• Using test tones to set up your speaker
RS
SB
Using the SR+ mode with a
Pioneer plasma display
When connected using an SR+ cable, a
number of features become available to make
using this receiver with your Pioneer plasma
display even easier. These features include:
• On-screen displays when making receiver
• On-screen volume display.
• On-screen display of listening mode.
• Automatic video input switching on the
• Automatic volume muting on the plasma
See also Using this receiver with a Pioneer
plasma display on page 26 for connecting up,
and SR+ control for Pioneer plasma displays
on page 48 for setting up the receiver.
1
this receiver are switched on and that
they are connected with the SR+ cable.
See Using this receiver with a Pioneer plasma
display on page 26 for more on connecting
these components.
2
RECEIVER, then the SR+ button.
The front panel display shows SR+ CHECK,
then the new setting is displayed (SR+ ON or
SR+ OFF).
low frequency its sound may seem quieter
than it actually is.
system will overwrite any previous
settings you had for the STANDARD or
ADVANCED SURROUND modes.
settings, such as speaker setup, MCACC
setup, and so on.
plasma display.
display.
Make sure that the plasma display and
To switch SR+ mode on/off, press
07
51
En
- Quick Links:
- Connecting the Speakers
- Subwoofer Setting
Hide quick links:
Advertisement
Table of Contents
