Table of Contents
Advertisement
Operation
Temp
Temp
System
Minus On/Off Plus
Lock
Status
keypad keypad keypad
DisplayArea
keypad
indicators
Electronic
Control
Display
BIG
Starting your appliance:
Plug the appliance power cord into a 115
volt wall outlet. Your appliance is shipped
from the factory in the "On" position and
will begin start-up of cooling as soon as
power is supplied. If the appliance does
not start, confirm that the wall outlet has
power, and that the control is in the "On"
position, (See "Turning your appliance On
and Off" below).
The control display is covered with a clear
plastic film. This film may be removed by
carefully lifting the film at a corner.
On initialpower up, the control display will
indicate a "Power Failure"alarm. This is
a normal condition as the appliance was
powered-up at the factory for quality inspection
and then removed from power. A momentary
press of the "On/Off" keypad will reset this
alarm condition. (SeeAlarms section).
//
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
CCCCCCCCIIIII
CCCCCCCCIIIII
To wake the display press any keypad. A
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
confirm tone will sound, and the current
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
storage compartment temperature will be
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
d,sp,ayed
iiiiiiiiiiiiiiii
/ll
iiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii_
iiiiiiiiiiii
iiiiiiiiiiiiiiiiiiii
Sleep mode:
If no keypads are pressed for 60 seconds,
the display will enter sleep mode to
conserve power. The control panel will
go dark with the exception of the system
status "OK" indicator which will remain
enabled. Alarm conditions will wake the
display, (SeeAlarms section).
To turn the appliance "On", press and hold
To make the following changes to the
the "On/Off" keypad for four seconds.
control settings (turning the appliance ON/
OFF, adjusting the temperature, changing
the interior lights, and activating vacation
mode), the control must be awake.
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
The sleep mode can be disabled if you
prefer to have the display on continuously.
Press and hold the "Lock" keypad until the
display goes past "Loc" and reads "nSL"
,..........................
To enablethesleep
mode, repeatthe
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
instruction, again going past "hoc" until the iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
disp,ayreadsSLP'
iiiiiiiiiiiiiii
iiiiiiiiiiiiiii
Turningyourappliance
ON and OFF:
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
If the appliance is "On", (and out of sleep
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
mode/thetemperaturewi,
beshowniniiiiiiiiiiiiiiiiiii
thedisplayareaofthe
control, Toturnthe
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
appliance"Oft",
pressand
ho dthe"On/ i iiiiiiiiiiiiiiiiii
Off" keypadforfourseconds,
"OFF" will
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
nowbedisplayedonthecontrol,
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiii
Advertisement
Table of Contents
