Changing The Display Starting Positions Of Pictures - Sony ZRD-1 Operating Instructions Manual
Display unit; display controller
Hide thumbs
Also See for ZRD-1:
- Service manual (102 pages) ,
- Operating instructions manual (23 pages) ,
- Installation manual (171 pages)
Table of Contents
Advertisement
DVI connector 1
DVI connector 2
Note
A picture can be displayed using only one DVI
connector. For details, refer to the Installation
Manual.
[DisplayPort (Single)]: Use one DisplayPort
connector to display the picture. Only
DisplayPort connector 1 can be used for this
setting. (DisplayPort connector 2 cannot be
used.)
For details on the supported video signals for display,
see "Signal Formats" (page 17).
[DisplayPort (Dual)]: Use two DisplayPort
connectors to display pictures as large as 4K
100p/120p.
Note
If you are only inputting single-stream signals that are
50p/60p or lower, we recommend clicking [Detailed
Input Settings] and clearing the [High Frame Rate
Mode] checkbox in the [Detailed Input Settings]
screen.
3
Click [OK] or [Apply] to apply the settings.
The setting values will be registered to the display
controller and saved to Display Control Software.
DVI connector 3
DVI connector 4
Changing the Display Starting
Positions of Pictures
You can change the display positions for each picture.
For example, you can move a low-resolution picture from
the top left of the screen to the center.
1
Click [Detailed Input Settings] in the [Input Settings]
screen.
The [Detailed Input Settings] screen appears.
2
Click the tab ([DVI], [DisplayPort (Single1)],
[DisplayPort (Single2)], or [DisplayPort (Dual)]) of
the video signal for which you want to change the
display starting position.
3
Use the sliders and
[V Position] to specify the horizontal and vertical
positions.
The settings are reflected in the picture immediately
after they are configured.
For details, refer to the Installation Manual.
4
Click [Close].
The [Detailed Input Settings] screen closes.
10
buttons for [H Position] and
Hide quick links:
Advertisement
Table of Contents
