Siemens SINUMERIK 840D sl Operating Manual page 429

Hide thumbs Also See for SINUMERIK 840D sl:

Table of Contents

- (only for ∇ machining)

- (only for unmachined part description, cylinder and allowance)

- (only for ∇ machining)

- (only for unmachined part description, cylinder and allowance)

Allowance for pre-finishing - (only for ∇∇∇)

Compensation allowance in X and Z direction (inc) – (only for allowance)

Set machining area

Set machining area limits

with limited machining area only, yes:

Number of grooves

Distance between grooves (inc)

* Unit of feedrate as programmed before the cycle call

Operating Manual, 09/2011, 6FC5398-7CP40-2BA0

For unmachined part description, cylinder

Version, absolute:

Cylinder dimension ∅ (abs)

Version incremental:

Allowance (inc) to maximum values of the CYCLE62 finished part contour

For unmachined part description, allowance

Allowance on the CYCLE62 finished part contour (inc)

For unmachined part description, cylinder

Version, absolute:

Cylinder dimension (abs)

Version incremental:

Allowance (inc) to maximum values of the CYCLE62 finished part contour

For unmachined part description, allowance

Allowance on the CYCLE62 finished part contour (inc)

U1 contour allowance

Positive value: Compensation allowance is kept

Negative value: Compensation allowance is removed in addition to finishing

1. Limit XA ∅

2. Limit XB ∅ (abs) or 2nd limit referred to XA (inc)

2. Limit ZB (abs) or 2nd limit referred to ZA (inc)

Programming technological functions (cycles)

8.5 Contour turning - only for G code programs

Sinumerik 828d