Siemens SINUMERIK 840D Programming Manual page 130
Hide thumbs
Also See for SINUMERIK 840D:
- Function manual (920 pages) ,
- Diagnostics manual (714 pages) ,
- Operating turning (713 pages)
Table of Contents
Advertisement
Milling Cycles
03.96
08.97
3
3
3.6 Circumferential slot - SLOT2
Further notes
A tool offset must be activated before the cycle is
called. Otherwise the cycle is aborted and alarm
61000 "No tool offset active" is output.
Contour violation
If incorrect values are assigned to the parameters
that determine the arrangement and size of the slots
and thus cause mutual contour violation of the slots,
the cycle is not started.
The cycle is aborted after the error message
61104 "Contour violation of slots/elongated holes".
is output.
During the cycle, the workpiece coordinate system is
shifted and rotated. The actual-value display in the
workpiece coordinate system is always displayed
such that the circumferential slot currently being
machined on the 1st axis of the current processing
level starts and the zero point of the workpiece
coordinate system lies in the center of the circle.
When the cycle is completed, the workpiece
coordinate system is again in the same position as it
was before the cycle was called.
Siemens AG 2000 All rights reserved.
3-130
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide, Cycles (PGZ) - 04.00 Edition
- Quick Links:
- Programming Cycles
- Programming
Hide quick links:
Advertisement
Table of Contents
