3.4.2 via the PBC method
Check that your Wireless router and that the other WPS device are
1
connected and ON
Push and hold the WPS button, located on the front side on your
2
router, for 3 seconds
Push and hold the WPS button of the other WPS device for
3
3 seconds (refer to the manual of the other WPS device for
location)
• The other WPS device is installed on your network
OR
Check that your Wireless router and that the other WPS device are
1
connected and ON
On your Internet Browser, enter http://192.168.2.1 in the address
2
field and click on GO to access the webpages
Click on the WIRELESS tab on the left side of the page and select
3
PBC to open the corresponding subpage
Click on START PBC
4
• The other WPS device is installed on your network
Note
The push and hold procedure on the two WPS buttons (router and
other WPS device) has to be done within a two minutes' interval.
3.4.3 via the Manual configuration
This method enables you to configure client devices without WPS
function.
On your Internet Browser, enter http://192.168.2.1 in the address
1
field and click on GO to access the webpages
Click on the WIRELESS tab on the left side of the page and select
2
Manual to open the corresponding subpage
Take note of the settings displayed and configure your non-WPS
3
device accordingly
• Your non-WPS device is installed on your network
Getting started
7