4.
Push the green release latch on the right rear side of the drive toward the center of the drive (1), and
then slide the drive forward and out of the bay (2).
Installing a 9.5 mm slim optical drive
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
blank, remove the bezel blank. See
4.
Disconnect the power cable (1) and data cable (2) from the rear of the drive.
IMPORTANT:
damaging the cable.
42
Chapter 4 Removal and replacement procedures – Microtower (MT) chassis
(Preparation for disassembly on page
(Access panel on page
(Front bezel on page
Removing bezel blanks on page 23
When removing the cables, pull the tab or connector instead of the cable itself to avoid
20)
21). If you are installing a drive in a bay covered by a bezel
19)
for more information.