Table of Contents
Advertisement
English
WARNING:
When servicing, use only identical replacement parts. Use of any other part may create a hazard
or cause product damage.
WARNING:
Always wear safety goggles or safety glasses with side shields during power tool operation or when
blowing dust. If operation is dusty, also wear a dust mask.
WARNING:
Before performing any maintenance, make sure the tool is unplugged from the power supply and
switch is in the off position.
WARNING:
DO NOT at any time let brake fluids, gasoline, petroleum-based products, penetrating oils, etc.,
come in contact with plastics parts. Chemicals can damage, weaken, or destroy plastic.
WARNING:
Make sure the blade guard is reinstalled immediately after finishing any maintenance which requires
it to be removed. Failure to heed this instruction could result in serious personal injury.
GENERAL MAINTENANCE
• Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various
types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust,
oil, grease, etc.
• Periodically check all clamps, nuts, bolts, and screws for tightness and condition. Make sure the table
insert is in good condition and level with the working table.
• Check the blade guard assembly after performing maintenance to make sure it is installed correctly and
functioning properly.
• Clean plastic part only with a soft damp cloth. DO NOT use any aerosol or petroleum solvents.
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient amout of high grade lubricant for the life of the
unit under normal operating conditions. Therefore, no further lubrication is required.
SERVICE AND REPAIRS
All quality power tools will eventually require servicing or replacement of parts because of wear from
normal use. To assure that only authorized replacement parts will be used and that the double insulation
system will be protected, all service (other than routine maintenance) must be performed by an AUTHORIZED
HITACHI POWER TOOL REPAIR CENTER ONLY.
NOTE:
Specifications are subject to change without any obligation on the part of HITACHI.
44
MAINTENANCE
- Quick Links:
- Table of Contents
- Assembly
- Operation
- Adjustments
- Troubleshooting
- Parts List
Hide quick links:
Advertisement
Table of Contents
