Table of Contents
Advertisement
Bracket
Checking the PTT operation
(ET)
1. Fully tilt the outboard motor up and down
a few times and check the entire trim and
tilt range for smooth operation. Check the
PTT fluid level if necessary.
NOTE:
Be sure to listen to the winding sound of the
PTT motor for smooth operation.
2. Fully tilt the outboard motor up, and then
support it with the tilt stop lever 1 to
check the lock mechanism of the lever.
1
61U5H11
Checking the PTT fluid level
(ET)
1. Fully tilt the outboard motor up, and then
support it with the tilt stop lever 1.
1
w
After tilting up the outboard motor, be
61U30280
sure to support it with the tilt stop lever.
Otherwise, the outboard motor could sud-
denly lower if the PTT unit should lose
fluid pressure.
2. Remove the reservoir cap 2, and then
check the fluid level in the reservoir.
w
Make sure that the trim and tilt rams are
fully extended when removing the reser-
voir cap, otherwise fluid can spurt out
61U30140
from the unit due to internal pressure.
NOTE:
If the fluid is at the correct level, the fluid
should overflow out of the filler hole when the
reservoir cap 2 is removed.
Control system/Bracket
61U30140
2
6G430380
1
2
3
4
5
6
7
8
9
3-10
Advertisement
Chapters
Table of Contents
